Positioning The Unit; Replacing The Bulb - Partyspace SUNBEAM 2400 Mode D'emploi

POSITIONING THE UNIT

1. When choosing a mounting position, it is important to ensure the heater lights are NOT
pointed towards combustible surfaces. To adjust, loosen the wing nuts on the side, set the
heater-light to desired position and re-tighten. Take care not to pinch the cable between
the back of the f ittings and the plate. DO NOT ADJUST WHEN HOT!
2. This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety.
3. Children should be supervised to ensure they do not play with the appliance.
4. Heater must be installed at least 1.8 m above the floor.
5. Only f it hardened tempered grill in this unit. Any other type of grill could melt and cause
damage to the unit or set on f ire.
6. Do not use this appliance again if the cable was destroyed.
7. Unit must not be modif ied in any way.
8. Do not use the heater if the power cord is damaged in any way – contact Heatmaster
for a replacement.

REPLACING THE BULB

1. Unplug the unit.
2. Loosen the screw at the top of the unit
and hinge the f ront open. Release the bulb
f rom the spring loaded lampholders. Insert
new bulb into lampholders ensuring it is
mounted within 4 degrees of horizontal
along its length. It is important that the
end-caps on the lamp are making good
contact with the lampholders.
Take care not to handle the bulb surface. Should the bulb be accidentally handled during
installation, it should be thoroughly cleaned with methylated spirit and a lint f ree cloth. Close
the f ront and tighten the screw. Spare parts are available f rom your supplier.
WARNING: DO NOT TOUCH THE UNIT BEFORE IT COOLS DOWN!
SUNBEAM 2400 | MANUAL