Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
the bowl.
•
A small amount of water can facilitate the smooth
running of the appliance.
•
The mixture amount should not exceed the max
capacity of the bowl.
4.
Close the lid.
5.
Assemble the motor unit into the bowl lid until the
two small buttons on the left and on the right of
the connector have clicked.
6.
Plug the appliance into the power outlet.
7.
Rotate the speed-adjusting dial to select the
desired speed. Pressing and holding the ON/
OFF button, the attachment starts chopping
immediately. For maximum speed press the
TURBO button for a short time.
8.
Remove the knife blade first before pouring out
the mixture.
•
Don't operate hard food for more than 10
seconds continuously.
FOOD PROCESSOR ATTACHMENT
Figure 8-9
To use the food processor attachment as a chopper
follow these instructions:
1.
First of all make sure the non-slip ring is fixed to
the bottom of the bowl.
2.
Fit the knife blade on the pin in the bowl - always
fit the knife blade before adding the ingredients.
3.
Cut the food into small pieces and put them into
the bowl.
A small amount of water can facilitate the smooth
running of the appliance.
The mixture amount should not exceed the max
capacity of the bowl.
4.
Rotate counter clockwise the lid until blocked in
position, as shown in pic. 10
Make sure the food pusher is properly fitted into its
housing on the cover.
5.
Assemble the motor unit into the bowl lid until the
two small buttons on the left and on the right of
the connector have clicked.
6.
Plug the appliance into the power outlet.
7.
Rotate the speed-adjusting dial to select the
desired speed. Pressing and holding the ON/
OFF button, the attachment starts chopping
immediately. For maximum speed press the
TURBO button for a short time.
8.
Remove the knife blade first before pouring out
the mixture.
•
Don't operate hard food for more than 10
seconds continuously.
•
To use the food processor attachment with
shredding/slicing inserts follow these instructions:
1.
First of all make sure the non-slip base is fixed to
the bottom of the bowl.
2.
Fix the desired insert into the blades support as
shown in pic. 11
3.
Put the support into the pin on the bottom of the
bowl.
4.
Rotate counter clockwise the lid until blocked in
position, as shown in pic. 10
The fasteners must be locked in the two clip positions,
otherwise during operating the bowl lid may rotate as
the motor rotates.
5.
Insert the bottom part of the motor unit into
the opening on the bowl lid, until the two small
buttons on the left and on the right of the
connector have clicked.
6.
Plug the appliance into the power outlet.
7.
Put the food inside the feeding tube and push it
slowly with the food pusher. Do not push heavily.
8.
Rotate the speed-adjusting dial to select the
desired speed. Pressing and holding the ON/
OFF button, the attachment starts chopping
immediately. For maximum speed press the
TURBO button for a short time.
To remove the blades support after using pull with two
fingers as shown in pic. 12
TIPS
•
Use the shredding side for carrots, potatoes and
foods of a similar texture.
•
Use the slicing side for food items such as
carrots,
potatoes,
courgettes and onions.
•
Use fresh ingredients.
•
Do not cut food too small. Fill the feed tube
uniformly. This prevents the food from pouring
out during processing.
Times and quantities in the tables are approximate
and could vary depending on the quality of ingredients
or preference.
it en
cabbages,
cucumbers,
21
Publicité
Table des Matières
