Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
Single Color
Remote Dimmer Controller
R217-S
USER'S MANUAL
• RF Remote Operation
• Smooth Change Effect
• Compact Design
Introduction
Thank you for purchasing our product. R217 series LED Dimmer is
designed to drive constant voltage LED products in voltage range
of DCSV-24V. It contains a main control unit and a RF wireless remote
controller. User can turn on/off or adjust LED brightness conveniently
via the remote controller.
Functions
1. Turn on/off
Press this key to switch on or off the controller.
Press and hold this key will force to switch off the controller.
The controller will memorize the on/off status and restore the on/off
status and brightness level on each power on moment.
2. Increase Brightness
Press this key to increase the output LED brightness.
Press and hold this key will continuously increase the brightness.
3. Decrease Brightness
Press this key to decrease the output LED brightness.
Press and hold this key will continuously decrease the brightness.
When controller is off, hold press this key will turn on the controller and jump to minimum brightness.
4. Remote Controller Indicator
This indicator will blink when remote controller works.
Installing
5. Power Supply
The controller unit can work from DC SV to 24V. The red power cable should be connected to
power positive and black to negative. Please make sure the power supply voltage is same as
the LED load and the power is capable for the load wattage.
• Full Protection
• Waterproof Option
• Multi Remote Option
• Easy Remote Pairing
6. LED Output
The controller unit supports constant voltage driving LED products. The red cable should
be connected to LED positive and black cable to negative. The red cable is internal
connected to power supply positive in controller unit.
The controller unit has output overload protection function, please check whether the
output is short circuit or over loaded if the controller stop working.
Operation
7. Status Indicator
This is a fu ll color status indicator. It displays all working status of the controller.
It indicates different events as following:
Blue: normal working.
Short single white flash: new command received.
Long single yellow flash: reach brightness limit.
Red flash: overload protected.
Yellow flash: overheat protected.
8. Using Remote
Please pull out the battery insulating tape before using.
The remote controller use CR2032 cell battery, it can last for 2 years for regular usage.
For proper receiving remote signal, please do not install the controller in closed metal
parts.
9. Pairing New Remote
The remote and main unit is 1 to 1 paired as default.
Further more, one main unit can be paired to 5 remote controllers and every remote can
be paired to any main unit.
Please do following steps to pair a new remote:
1. Plug off the power of main unit and plug in aga in after more than 5 seconds.
2. Press remote 'on/off' and 'decreasing brightness' key together in 5 seconds after main
unit powered on.
After this operation, the controller's indicator will flash white for 3 times to display the
new remote is accepted. The latest paired 5 remote controllers can be recognized.
10. Optional Wall Switch Remote
The controller can also work with the optional wall switch type remote controller RM07.
This remote controller has the same function and usage as the default hand hold remote
controller.
It can be slicked on the wall for fixed place operation.
Publicité
Table des Matières
