Instructions For Use - Flex AP 12.0-US Notice D'instruction D'origine

Instruction manual
(f) The battery voltage must match the
battery charging voltage of the battery
charger. Otherwise there is a risk of fire and
explosion.
(g) Recharge only with the charger specified
by the manufacturer. A charger that is
suitable for one type of battery pack may
create a risk of fire when used with another
battery pack.
(h) Pointed objects, such as nails or screw-
drivers, or external forces may damage the
battery. This may cause an internal short-
circuit and the battery to burn, smoke,
explode or overheat.

Instructions for use

CAUTION
– Never charge batteries at temperatures
below 41 °F or above 104 °F.
– Do not charge batteries in an environment
which has high air humidity or at a high
ambient temperature.
6
– Do not cover batteries and/or the battery
charger during the charging process.
– At the end of the charging process pull out
the battery charger mains plug.
The battery and battery charger heat up
during the charging process. This is normal!
Lithium ion batteries do not exhibit the well
known "memory effect".
Nevertheless, before a battery is recharged,
it should be fully discharged and the
charging process always run to the end.
NOTE
– Follow the instructions for charging the
battery in the operating instructions for the
electric power tool and the battery charger.
– Reduced operating times after recharging
indicates that the battery is worn out. The
battery must be replaced.
If the batteries are not used for a prolonged
period, store batteries partially charged and
in a cool location.
AP 12.0-US / AP 18.0-US