KNIPEX MicroCrimp 97 52 63 Mode D'emploi page 11

Owner's Manual 4/8 Indent Crimping Tool MicroCrimp
3 Exchange of Locators
• Loosen the center hex head screw with an Allen wrench (SW 2.5 mm); you may want to use a second
Allen wrench on the opposite side
• Remove the locator
• Fasten the other locator (optional) by using the Allen wrench
4 Crimping Dimension Adjustment
All precision settings are adjusted by using the adjustment wheel; the wheel is turned clockwise for crimp
dimension decreases and counterclockwise for crimp dimension increases. The adjustment of the crimp
dimensions (crimping depth of the indenters) can be changed through the adjustment wheel and may be
modified by using the following steps:
Positioning accuracy
· 1 scale mark on adjustment wheel
· 1 360° turn of the adjustment wheel =
· 5 360° turns of the adjustment wheel =
Scale with 1 mm and 0.2 mm Increments
Rev.: 2016-06-13
= 1/100 mm increment
0.2 mm increment;
the adjustment wheel
1 mm increment;
adjustment wheel
Adjustment Wheel with 0.01 mm
Increments
- Crimp dimensions decrease (-)
- Crimp dimensions increase (+)
indicated on the
indicated on the scale
EN
scale of
of the
5 / 6