Westinghouse WFVC001 Instructions page 9

Remove, wash and replace brush bar
1. Be careful not to pull the power trigger.
2. Disassemble the motorized floor brush from electric extend tube, turn the
cleaner head upside down so the underside of the cleaner head is facing you.
3. Push the brush bar release cover button as arrow indication, then take the brush
bar out for cleaning
4. Before replacing, check that the brush bars are completely dry.
5. Slide the brush bar back onto motorized floor brush, The end cap should be in
the open position as below shown. Once in place, close the brush bar release
cover button.
WFVC001_Vacuum Cleaner_6L_IB.indd 9
EN
9
22/10/2019 16:31:56