Using The Vacuum Cleaner; Care And Maintenance - Westinghouse WFVC001 Instructions

USING THE VACUUM CLEANER

ATTENTION: Do not use without the dust bin and filters in place.
When the motor unit was fully recharged and the unit was assembled with the
accessories of your choice:
1. Pull the trigger located on the handle. The device starts at a high speed and the
charging indicator lights up in green.
2. Press the speed selector button to change to slow speed. Press this button
again to return to high speed. The vacuum works appox. 25 - 30 minutes in slow
speed, appox. 15 minutes in high speed.
3. If necessary, empty and clean the dust bin and filter block (see section
CLEANING AND MAINTENANCE).
4. Disassemble the unit and place the motor unit on the base to recharge it.
BRUSH BAR BLOCKAGES - AUTOMATIC CUT-OUT
This machine is fitted with an automatic cut-out.
1. Once the brush bar block or twine, the machine will automatically cut out and
three indication lights fast flash green color
2. Ensure the machine is disconnected from the charger and be careful not to pull
the power trigger before looking for blockages. Failure to do so could result in
personal injury.
3. Clear any blockage refer to the section CARE AND MAINTENANCE.

CARE AND MAINTENANCE

WARNING: Do not immerse the motor unit in water.
Emptying the dust bin
1. Empty as soon as the dirt reaches the level of the MAX mark - do not overfill.
2. Be careful not to pull the Power trigger.
3. To make emptying the dust bin easier, it is advisable to remove the extend tube
and the accessory.
4. Empty the dust bin, press dust bin bottom release button.
WFVC001_Vacuum Cleaner_6L_IB.indd 7
2 in 1 brush
Slide the head to the end to put it in brush position
for cleaning furniture, frames etc.
Slide the head down to put it in suction position for
fabrics, mattresses, sofas, etc.
Speed control
Power trigger
EN
7
22/10/2019 16:31:56