Simplicity SLF4 Manuel D'instruction page 8

2
Mount the Wall Plate
Wood stud
2-1
Locate studs
41 - 61 cm
(16 - 24 in.)
2-2
Mark the wall
2-3
Drill pilot holes
2-4
Tighten lag bolts
[19]
[18]
8
Verify the center of the stud(s) using an awl, a thin nail, or an edge to
edge stud fi nder.
damage!
< 16 mm
(5/8 in.)
For assistance in determining wall plate location, see Height Wizard at
simplicityav.com. Level the wall plate template [28] and mark the hole
locations.
[28]
holes MUST be drilled to a depth of 75 mm (3 in.), using a 5.5 mm (7/32
in.) diameter drill bit.
[01]
CAUTION:
Avoid potential personal injuries and property
Any material covering the wall must not exceed 16 mm (5/8 in.).
Minimum wood stud size: common 2 x 4 in. (nominal 1.5 x 3.5 in.).
CAUTION:
Avoid potential injuries or property damage! Pilot
CAUTION:
Avoid potential injuries or property damage!
Improper use could reduce the holding power of the lag bolt. To
avoid potential injuries or property damage
DO NOT over-tighten the lag bolts [18].
Tighten the lag bolts [18] only until the washers [19] are pulled
fi rmly against the wall plate [01].
13 mm 5.5mm
(1/2 in.) (7/32 in.)
75 mm
(3 in.)
6903-002007 <02>