Table des Matières
Publicité
CLEANING & MAINTENANCE
To clean the toilet, use warm, soapy water; rinse thoroughly with fresh water and dry with a soft cloth. Avoid detergents, disinfectants,
or cleaning products in aerosol cans. NEVER use abrasive powders scouring powders or pads on the toilet seat. Some bathroom
chemicals and cosmetics may damage the seat's finish.
!
WARNING: Do not use in-tank cleaners. Products containing chlorine (calcium hypochlorite) can seriously damage fittings in the
tank. This can cause leakage and property damage.
PROBLEM
POSSIBLE CAUSE
a. Water supply valve is closed.
Does not flush
b. Supply line blocked.
a. Bowl water level too low.
Slow or weak
b. Supply valve partly closed.
flush
c. Partially clogged trapway.
d. Supply pressure too low.
a. Poor supply line connection.
Toilet leaks
b. Poor bowl to tank/floor connection.
a. Flush valve seat and/or seal worn or deformed.
Toilet does not
shut off
CMG09-2018
Rencontre la norme B651-04 de l'ASSOCIATION
DES STANDARDS CANADIEN.
Meets the standard B651-04 of the CANADIAN STANDARDS ASSOCIATION.
QUEBEC
BLANC / WHITE
3021103
Fabriqué et emballé en Chine /
Made and Packaged in China
Importé par / Imported by NOVELCA
TASS I LI . CA
Québec, Canada G2J 1C8
TROUBLESHOOTING GUIDE
SOLUTION
a. Open valve and allow water to fill tank.
b. Shut off water supply, disconnect supply line, and inspect all
gaskets and washers. Reassemble. See "Maintenance".
a. Check that the refill tube is connected to the water fill control
regulator and inserted into the refill float without being kinked
or damaged.
b. Open the supply valve completely. Be sure that the proper
supply tube is used.
c. Remove any obstruction. Consult a plumber if necessary.
d. Normal supply pressure must be at least 20 psi
a. Review step 9 of the installation procedure.
b. Reviews steps 4 to 6 of the installation procedure.
a. Replace seal/flush valve assembly as needed.
- 4 -
Publicité
Table des Matières
