Table des Matières
Publicité
SINGLE-FLUSH TOILET UNIFORM
Read all instructions in this guide in order
to properly install the product.
!
CAUTION: PRODUCT IS FRAGILE. HANDLE WITH CARE TO AVOID BREAKING AND INJURY.
NOTE: Illustrations may not correspond exactly to the shape of package components.
RECOMMENDED TOOLS & MATERIALS
- Putty Knife
- Flathead Screwdriver
- Adjustable Wrench
- Sealant
1
REMOVING OLD TOILET
a) Turn off the toilet supply valve and flush toilet completely. Wipe
any remaining from the tank and bowl with a towel or sponge.
b) Disconnect and remove the supply tube. NOTE: If replacing the
valve, shut off the main water supply first.
c) Remove the old mounting bolts, remove the old toilet, and plug
the floor waste opening to prevent sewer odours.
d) Remove the toilet flange bolts and clean the old wax, putty, etc.
from the base.
NOTE: The mounting surface must be clean and level before
installing the new toilet.
3
INSTALLING MOUNTING BOLTS
Insert the mounting bolts into the flange openings and slide them
into place parallel to the wall.
RETAINING WASHER
12"
FLOOR BOLTS
TOILET FLANGE
- Tape Measure
- Hacksaw
- Wax Ring
- Flexible Supply Tube
2
NOTE: The distance between the wall and the centreline of the
toilet flange must be 12 in. (30.5 cm).
FINISHED WALL
12" (30,5 cm)
4
Invert the toilet on the floor (cushion to prevent damage) and
install the wax ring evenly around the floor drain with the tapered
end of the ring facing the toilet.
- 2 -
- Mounting Bolts
- Level
ROUGH-IN DIMENSIONS
FINISHED FLOOR
INSTALLING WAX RING
WAX RING
SEALANT
SUPPLY
AS
REQ'D
Publicité
Table des Matières
