UBERHAUS DESIGN 38115077 Guide De L'utilisateur page 5

Fig.1: Attach stake cover (C) to post (A), then fix
(BB).
Fig.2:
Fix lower slanting beam connector (K) which inserted into post (A) with cross recessed bolt (AA) and
flat washer (BB).
Fig.3: Insert short valance 2(E)(or long valance2(G)) to short valance 1 (D)(or long valance1(F)), then fix
with bolt (CC), flat washer(BB) and nut(GG), and cover
Fig.4: Lock assembled valance to post (A) with bolt (DD) and flat washer (BB)，then cover bolt(DD)with
plastic cover(HH).
Fig.5: Lock inside of valance with bolt (DD) and flat washer (BB), then cover bolt (DD) with plastic cover (HH).
Fig.6: Install supporting bar (F) to valance and post with bolt (AA) and flat washer (BB).
Hardware Pack 2
AA
BB
M6 x15 bolt
M6 flat washer
stake plate B) and post (A)
bolt (CC) with plastic cover(HH)
4PCS
4 PCS
with bolt (AA) and flat washer