Step 5 - Install Range - Robam JJZ(Y/T)-G517K Instructions D'installation

CONNECT GAS LINE FROM GAS PRESSURE REGULATOR TO GAS SUPPLY:
1. Apply pipe-joint compound made for use with LP gas to the tapered (NPT)
threads of both adapters
2. Attach one adapter to the gas pressure regulator and the other to the gas
shutoff valve and tighten both.
NOTE: Do Not rotate the gas pressure regulator.
3. Attach the flexible gas line
IMPORTANT: All connections must be wrench tightened (requires two 10"
adjustable wrenches). Do not over-tighten the connections to the gas pressure
regulator. Overtightening may crack the regulator creating a leak.
COMPLETE CONNECTION
1. Open the manual shutoff valve in the gas supply line. The valve is open when the
handle is parallel to the gas pipe.
2. Test all connections by brushing on an approved noncorrosive leak-detection
solution. If bubbles appear, a leak is indicated. Correct any leak found.
3. Plug in range or reconnect power.

STEP 5 - INSTALL RANGE

IMPORTANT: If the range is moved to adjust the leveling legs, make sure when you
move the range back into its final location that the anti-tip bracket is engaged by
repeating steps 1 through 8.
1. Slide range into final location, making sure rear leveling leg slides into anti-tip
bracket. Leave a 1" (2.5 cm) gap between the back of the range and the back wall.
2. Place the outside of your foot against the bottom front to keep the range from
moving, and then grasp the back of the range, as shown.
supplied with gas line kit.
d
to adapters
c
e
a
d
c
b
d
, one adapter at each end.
d
a
Adapter (provided)
b
Gas Pressure Regulator
c
Gas Supply Line
d
Adapters (From Gas
Supply Line Kit)
e
Gas Shutoff Valve
Dual Fuel Range
21