Dry Ironing - Morphy Richards Elite Mode D'emploi

42286-8MEE 9/3/07
5 Begin first time ironing with an old
towel. Note: If you press the steam
button before the steam generator
reaches its required temperature a
warning double bleep will sound.
6 The appliance is ready to use.
7 Press the steam button ⁄ for
steam ironing.
8 Depress the power switch to turn
off the base unit when ironing is
complete.

Dry ironing

1 Connect the appliance to a suitable
mains outlet.
2 42288 Only. Press the steam
switch Î 2 times until all three
steam level indicator lights go off
(steam off mode).
3 Turn the temperature dial on the iron
in a clockwise direction, select dot-
1, dot-2, or dot-3 according to the
recommendation of the garment
label.
4 The temperature indicator light
glows on the iron indicating that it is
switched on.
5 When the required temperature is
reached, the temperature indicator
light on the iron goes off. The iron is
ready to use.
It is always a good idea to begin
with 'cool' fabrics and work up to
higher settings.
An iron heats up quicker than it
cools down so you'll save time and
electricity.
Auto-shut off (42288 only)
An auto-shut off system will activate
if the steam is not used for over 15
minutes. The mains indicator light
Á will flash between green and red
indicating the unit is in 'sleep
mode'.
When this occurs, press the steam
select button Î or the power
switch Á 'ON' once. The appliance
will switch on immediately and you
need to check, and select the
required setting.
11:45 Page 7
ANTI-SCALE SYSTEM
The anti-scale cartridge is designed
to reduce the build-up of limescale
which occurs during steam ironing,
this will prolong the working life of
your iron. However, please note that
the anti-scale cartridge will not
completely stop the natural process
of limescale build-up.
When the cartridge needs replacing
the indicator light  will flash.
NOTE: The unit will not switch off.
But you need to replace the
cartridge as soon as possible.
Replacing anti-scale
medium
1 When the indicator light flashes you
need to replace the anti-scale
cartridge.
2 The steam generator needs to be
connected to the mains supply.
3 Remove the tank from the base unit.
4 Remove the anti-scale cartridge
which is situated behind the tank,
and replace the cartridge making
sure the replacement unit is pushed
firmly in position.
5 Re-position the tank.
6 If the cartridge is not fitted correctly
the unit will not function. The 'calc'
light will flash accompanied by a
beep sound.
Re-fit the cartridge and the unit will
operate as intended.
Note: A cartridge should filter 40
litres of hard water.
Replacement anti-
scale refills
To obtain replacement anti-scale
refills check with your local
distrubator.
1 If a new re-fill is not available you
may continue operating the
appliance but scale will build up in
the system. Replace the anti-scale
refill as soon as possible.
Part Number 01030
C
C C
g
Cartridge
Drawer
7