Fuel Lines; Fuel Filter; Pump Pressure Adjustment - ProFitter KFA400PF2 Manuel D'utilisation

ProFitter Operating Instructions and Parts Manual
TM
ProFitter
Portable Oil-Fired Heaters
Maintenance (Continued)
PHOTOCELL
CLEAN PHOTOCELL ANNUALLY OR AS
NEEDED.
- Remove upper shell (See page 7).
- Remove photocell from photocell
bracket and disconnect photocell from
connector.
- Clean photocell lens with cotton swab.
- Inspect photocell for damage. If
damaged, replace photocell.
Photocell Bracket
Photocell
Photocell Lens Install Photocell
1) Incorrect
2) Correct
Figure 14 – Clean Photocell Lens

FUEL LINES

TIGHTEN FUEL LINES ANNUALLY OR
AS NEEDED.
- Remove upper shell (See page 7).
- Use 1/4" wrench and tighten fuel line
(A) at solenoid valve and at pump (See
Figure 15).
- Remove fan guard (See Figure 16).
- Use 3/8" wrench and tighten fuel line
(B) at pump and pump fuel filter
assembly.
- Reinstall fan guard.
For Technical Support or Troubleshooting, Call: 1-877-447-4768, 8:30 am - 4:30 pm CST www.ghpgroupinc.com
TM
Burner Head
Solenoid
Valve
Fuel Line (A)
Figure 15 – Tighten Fuel Line
Connector
Figure 16 – Remove Fan Guard

FUEL FILTER

CLEAN TWICE PER HEATING SEASON OR
AS NEEDED.
Tank Fuel Filter
- Remove fan guard (See Figure 16).
- Disconnect fuel line (B) from pump
and pump fuel filter assembly with
3/8" wrench (See Figure 17).
- Remove two screws that fix bracket-
filter to shell lower and remove
bracket-filter.
- Carefully pry fuel filter loose from fuel
tank with flat end of screwdriver.
- Wash fuel lines and fuel filter with
clean kerosene.
- Replace fuel filter into fuel tank.
- Replace bracket-filter to shell lower.
- Connect fuel lines (B) to pump and
pump fuel filter assembly.
- Reinstall fan guard.
Fuel Line (B)
Fan Guard
Screw
Flat Washer
8
Model KFA400PF2
Pump
Screw
Shell Lower
Bracket-Filter
Pump Fuel Filter Assembly
Figure 17 – Remove Tank Fuel Filter
Pump Fuel Filter
- Remove fan guard (See Figure 16).
- Unscrew filter bottom clockwise from
filter top with adjustable pliers.
- Remove fuel filter, gasket, magnet-
from filter bottom (See Figure 18).
- Wash filter bottom with clean
kerosene.
- Wipe inside of filter bottom dry with
clean cloth.
- Wash Fuel filter in clean kerosene.
- Remove dirt attached to magnet.
- Put clean magnet, fuel filter and
gasket back in filter bottom.
- Tighten firmly.
Figure 18 – Fuel Pump Filter

PUMP PRESSURE ADJUSTMENT

- Remove pressure gauge plug from-
pump with 1/8" Allen wrench.
- Install accessory pressure gauge to
pressure gauge port (See Figure 19).
Fuel Line(B)
Fuel Filter
Filter Top
Gasket
Fuel Filter
Magnet
Filter
Bottom