Getting Started - auna Moving 80.1 LED Mode D'emploi

EN

GETTING STARTED

Battery charging
This device is equipped with a with a rechargeable battery. The batty will be
charged automatically as soon as the device is connected to power. After
recharging, the device switches to trickle charging. However, do not leave
the device constantly connected to a socket. Turning off the device via
remote control switches it to standby mode, which consumes more power
than switching it completely off at the panel of the appliance.
ATTENTION: Before first use, fully charge the battery for at least 8
hours. Only after having charged the battery for 3 times, the battery
reaches its full capacity.
Charge the battery before and after each usage for a lasting battery
performance.
When the unit is turned off using the remote control, it is still in standby
mode and consumes more power than when turned off completely.
Be sure to fully charge the unit's internal battery before using it for the first
time on the move (without AC power).
Connect the device to an ordinary wall socket via power adapter. The
charging time is about 5.8 hours. The state of charge is indicated by the LED
on the back. The LED will got out when the batty is fully charged.
Microphone Use
Unscrew the battery cover on the lower part of the microphone. Insert 2
batteries and mind the polarity.
Set the volume to the minimum. Power the system on so that the power
LED lights up. Switch the microphone on and set the volume control to the
desired position.
Check for microphone feedback (howling). Reduce the treble signal. If the
problem still occurs, reduce the speakers or move the audio system. Do not
hold the microphone near the speakers.
22