Inserting Battery - Domo DO7032 Mode D'emploi

Tondeuse nes et oreilles
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

DO7032
instructions from that person on how the device is to be used.
OPERATION
Make sure that the appliance is in perfect working order. The nose/ear trimmer can
only be operated with a 1,5V alkaline battery of type LR6.

INSERTING BATTERY

To insert or change the battery hold the appliance with the cutting heat downwards.
The bottom of the housing can then be removed by turning anticlockwise. Insert the
enclosed battery. Make sure that you have first removed the protective film from the
battery.
Make sure that polarity is correct. Replace the housing bottom and turn it clockwise
until it will turn no further.
When using the appliance, always use a mirror.
Clean the trimmer after use as described in the instruction booklet.
SWITCHIN THE TRIMMER ON AND OFF
Before use, pull off the protective cap, press the on/off switch and slide it upwards to
switch the appliance on or slide it downwards to switch it off again.
USING THE CUTTER ATTACHEMENT
Remove the protective cap of the cutter attachment, turn the unit on the blade rotates
and you can start trimming the small hairs in the nose and ear. The integrated light is
useful aid here.
USING THE CONTOUR ATTACHEMENT
Switch off the appliance. Remove the cutter attachment for the nose/ear-hair trimmer
from the appliance by turning it anticlockwise. The contour attachment is put on the
housing by turning in clockwise direction whilst simultaneously applying pressure.
Draw the contour attachment along the skin at a flat angle from the top downwards
without pressure.
Attention: Do not push the appliance from below upwards and do not draw it
sideways. This could cause injury.
Caution: When cleaning the appliance, make sure that the battery compartment/
appliance bottom is firmly closed.
Do not immerse the appliance in water or in any other liquid.
CLEANING AND STORAGE
Hold the switched-off appliance with the cutting head upwards. To clean the cutter
attachment, remove the cutting head upwards by turning it anticlockwise and rinse it
16

Publicité

Table des Matières
loading

Table des Matières