Ground Zero Mobile Entertainment Uranium-DX Serie Mode D'emploi page 10

Wiring connection
Attention! – min. 20mm² wires are necessary for power connection!
(1) Ground: Ground connection should be passed directly to the car body as short as possible
(max. 1m)
(2) +12 Volt: Power connection should be passed directly to the battery. Please pay attention
on a correct fuse protection of the installation with an Inline device with a max. wire
length to the battery of 30 cm.
(3) Remote turn on: This connection is getting connected with the remote control line of the
radio. It is used for turning on and off the amplifier.
Power connection
RCA connection
This amplifier has a signal input terminal of RCA connector type for low level inputs. Adjustment
of input levels is accomplished by the gain control of both channels. Adjusting this control allows
the amplifier gain to be controlled to match and balance both channels. The RCA input connector
should be used when connecting the radio/cassette line out and this connection is usually made
using RCA-RCA connector wires.