BGS technic 8858 Mode D'emploi page 9

V ATTENTION
•
The auto-darkening welding helmet is not suitable to laser welding and oxygen acetylene
welding.
•
Do not put weld cap and filter near heat or damp place.
•
Do not remove the filter from the welding cap or open the filter box without authorization. Before
operation, please confirm the welding or grinding function selection is correct.
•
The protective plate must be installed to protect the filter away from damage.
•
Do not make any amend or replacement of weld cap or ADF without authorization.
•
Stop using immediataly if the filter can't change to dark and contact the dealer.
•
Do not use alcohol, petrol or thinner to clean filter, do not immerse it in water.
•
Operation temperature: -5°C - +55°C (23°F - 131°F) the reaction of ADF will be slow down if the
ambient temperature is too low. But it does not affect the protective performance.
•
Replace protective films immediately if it's broken or scratched. Since it may affect view and
seriously reduce the protective performance.
•
Replace protector immediately if it's broken or scratched. Do not use hard objects to contact
filter lens surface, in order to prevent damage to the filter
•
Clean filter surface, sensors and solar cells regularly.
•
Helmet can not prevent serious impact. explosive or corrosive liquid damage.
Note: serious personal injury will be incurred if users do not follow the above-mentioned attentions.
VI FAQ
FQA
Filter do not darken or flicker
React slowly
Filter is not clear
Welding cap slips
CAUTIONS
You should stop using the product immediately and contact dealer if the above-mentioned questions
can not be solved.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
REASONS
Protector is polluted or damaged
Arc sensor is not clear
Welding current is to small
Battery is low
Ambient temperature is too low
Sensitive setting is to low
Protector is stained
Protective film is not removed
Filter lenses have stains
Ambient light is insuffient
Shade No. is not set correctly
Headband is not adjusted
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
SOLUTIONS
clean or replace it
clean the surface of sensor
adjust sensitivity properly
replace battery
do not use below -5 degrees
raise sesitivity properly
clean or replace protector
remove the protective film
wipe both sides of the filter lenses
adjust the light of the workplace
reset the shading number
adjust the fixed nuts of headgear
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed