Instructions For Safe Operation - Hoyer Mix it! SSM 300 A Mode D'emploi

__RP106752_B2.book Seite 30 Dienstag, 18. November 2014 5:40 17

Instructions for safe operation

~ This device must not be used by children.
~ Children should not be allowed to play with the device.
~ The device and the power cable must be kept away from children.
~ This device can be used by people with restricted physical, sensory
or intellectual abilities or people without adequate experience
and/or understanding if they are supervised or instructed on how
to use this device safely and if they are aware of the resulting risks.
~ Disconnect the mains plug from the wall socket...
... when it is not supervised,
... before you assemble or disassemble the device, and
... before you clean the device.
~ Clean the blender 5 manually in washing-up water, rinse with clear
water and allow it to dry completely before putting it away.
DANGER for children
~ Packing materials are not children's
toys. Children should not be allowed to
play with the plastic bags. There is a
risk of suffocation.
~ Keep the device out of the reach of chil-
dren.
DANGER! Risk of electric
shock due to moisture
~ This device must never be operated
close to a bathtub, shower, filled hand
basin or similar.
~ The motor unit, the power cable and the
mains plug must not be immersed in wa-
ter or other liquids.
~ Protect the motor unit from dampness
and dripping and splashing water.
~ Should liquids enter the motor unit, pull
out the mains plug immediately. Have
the device checked before reusing.
~ Never touch the device with wet hands.
~ If the device falls into water, disconnect
the mains plug immediately. Only then
is it safe to retrieve the device.
30 GB
DANGER! Risk of electric
shock
~ Only plug the mains plug into a wall
socket if the motor unit has been con-
nected to the hand blender.
~ Only connect the mains plug to a prop-
erly installed and easily accessible wall
socket whose voltage corresponds to
the specifications on the rating plate.
The wall socket must continue to be eas-
ily accessible after the device is
plugged in.
~ Ensure that the power cable cannot be
damaged by sharp edges or hot points.
Do not wrap the power cable around
the device.
~ The device is not fully disconnected from
the power supply, even after it is
switched off. In order to fully disconnect
it, pull out the mains plug.
~ When using the device, ensure that the
power cable cannot be trapped or
crushed.
~ To pull the mains plug out of the wall
socket, always pull on the mains plug,
and never on the power cable.