Samsung NV51K6650S Serie Manuel D'utilisation page 36

Maintaining your appliance
Before a self-cleaning cycle
Fig. 1
Don't hand
clean the
oven door
gasket.
You may
hand clean
the door.
Fig. 2
NOTE
Remove oven racks and accessories before starting the self-clean mode.
36 English
NV51K6650S_DG68-00855A-03_EN+MES+CFR.indb 36
• We recommend venting your kitchen
with an open window or using a
ventilation fan or hood during the self-
cleaning cycle.
• Remove the wire rack, broil pan, broil
pan insert, all cookware, and any
aluminum foil from the oven.
• Wipe up debris from the oven bottom.
(Fig. 1)
• The silver-colored oven racks can be
self-cleaned, but they will darken, lose
their luster, and become hard to slide.
• Residue on the front frame of the oven
and outside the gasket on the door
will need to be cleaned by hand. Clean
these areas with hot water, soap-filled
steel-wool pads, or cleansers such as
Soft Scrub. Rinse well with clean water
and dry.
• Do not clean the gasket. The fiberglass
material of the oven door gasket cannot
withstand abrasion. It is essential for
the gasket to remain intact. If you
notice it becoming worn or frayed, have
it replaced. (Fig. 2)
• Make sure the oven light cover is in
place and the oven light is off.
How to run a self-cleaning cycle
Select the length of time for the self-cleaning operation, eg. 3 hours.
1.
Touch Self Clean 2/3/5h once for a 3 hour clean time, twice for a 5 hour clean
time, or 3 times for a 2 hour clean time
The default setting is 3 hours.
2. Touch START/SET to start the self-cleaning cycle.
The motor-driven door lock will engage automatically.
NOTE
• You will not be able to start a self-cleaning cycle if the Control Lockout
feature is activated or if the oven's temperature is too hot.
• The oven door locks automatically. The display will show the cleaning
time remaining. You cannot open the oven door until the temperature
drops to a safe/cool temperature.
3. When the self-cleaning cycle is done, End will appear in the display and the
oven will beep 6 times.
How to delay the start of self-cleaning
1. Touch Self Clean 2/3/5h.
Select the desired self-clean time by touching Self Clean 2/3/5h.
2. Touch Delay Start.
3. Enter the time you want the self-clean cycle to start.
4. Touch START/SET.
The display will show Delay, Self clean, and the Lock icon. The motor-driven
door lock will engage automatically.
5. The Self-Cleaning cycle will turn on automatically at the set time.
How to turn off the self-cleaning feature
If you need to stop or interrupt a self-cleaning cycle:
1. Touch OVEN OFF.
You will be able to open the oven door once the oven has cooled down for
2.
approximately 1 hour.
2018-08-29 1:06:27