Cafe CDT706 Serie Manuel Du Propriétaire page 9

Masquer les pouces Voir aussi pour CDT706 Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Getting Started
Select Options
5
The light by the selected pad will be lit to indicate which Option has been selected.
Normal
This option is for normally soiled dishes, optimizes wash performance while conserving energy.
Temp
Wash
This option increases the temperature to help clean heavily soiled dishes and will increase the
Temp
cycle time by 20 to 50 minutes. Option may be turned On or Off during the wash cycle. This
Boost/
option will also improve dry performance on the Normal cycle.
Boost
Temp/
Hi-Temp
Wash
Wash
This option raises the water temperature in the final rinse to sanitize your dishware but may
Temp
increase cycle time by 60 minutes. The cycle length will vary depending on the temperature of
Sani/
your inlet water.
Sanitize
NOTE: This option is monitored for sanitization requirements. If the cycle is interrupted during
Temp/
or after the main wash portion or if the incoming water temperature is so low that adequate
Presoak
water heating cannot be achieved, the sanitizing conditions may not be met. In these cases, the
+ Sani
Sanitized or Cycle Sanitized light will not illuminate at the end of the cycle. Utilizing this option
will modify the cycle to meet the requirements of Section 6, of the NSF 184 Standard for soil
removal and sanitization efficacy.
NOTE: Certified residential dishwashers are not intended for licensed food establishments.
Heated
Off - Shuts off the drying option. Dishes air dry naturally and energy is saved. Open the
Dry / Dry
dishwasher door to speed drying.
On/Normal -Turns on the option for faster drying. This option may extend the time to your wash
cycle up to 85 minutes. This option is not available with the Rinse/Express cycle.
Ultra (on some models) -This option can be selected by pressing the Heated Dry/Dry pad twice
to illuminate the Ultra light. It will add additional time to your drying option, further enhancing the
dishwasher's performance for difficult to dry items.
Steam
For use with heavily soiled and/or dried-on, baked-on soils. This option MUST be selected
(Prewash)
PRIOR to starting the cycle. The Steam option adds up to 30 minutes to the cycle time. This
(on some
option is available with Heavy/Pots, AutoSense/Auto, and Normal cycles.
models)
Pre Soak
Use this option to improve wash performance with heavy or dried-on soils. This option is
(on some
available on Heavy/Pots, AutoSense/Auto, and Normal cycles and may add up to 30 minutes
models)
to the cycle time.
Wash
Selecting either the Upper or Lower Wash Zones will target dishwashing of just one rack. This
Zones
will shorten the cycle time and conserve energy. This option should be used when dishes are
(on some
placed in only one rack.
models)
Bottle Jets
This option increases the time that the bottle jets are on and may add up to 23 minutes to the
(on some
cycle time. Use this to wash difficult to clean, dishwasher safe baby bottles, sport bottles, tall
models)
coffee cups, etc. See use recommendations in the
Delay
Delays the start of a wash cycle up to 8 to 12 hours depending on model. Press Delay Hours/
Hours/
Delay, to select the number of hours, then press Start one time and close door to begin
Delay
countdown. The cycle will start once allotted time has expired.
Control
You can lock the controls to prevent selections from being made. You can also lock the
Lock
controls after you have started a cycle to prevent cycle changes. For example, children cannot
accidentally start the dishwasher by pressing pads with this option selected.
To LOCK the dishwasher control, depending on the model, press and hold the 1 or 2 pads
indicated on the controls for 3 seconds. On some models, it will be the Heated Dry/Dry, another
the Steam and Wash Temp pads, another the Wash Temp Sani/Presoak+Sani pad, and
another model is the Pre-Soak and Bottle Jets pads. The Control Lock light will turn on to
indicate the control is locked.
To UNLOCK the dishwasher control, depending on the model, press and hold the 1 or 2 pads
indicated on the controls for 3 seconds. The Control Lock light will turn off to indicate the control
is unlocked.
8
Loading
section.
49-4000042 Rev 4

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Cdt800 serieCdt855 serieCdt836 serieCdt875 serie

Table des Matières