ATiB RDCV Manuel page 16

RDCV
AUTOMATE RÉSIDENTIELLE
NUMÉRIQUE
HOLDING REGISTERS (Read / write)
Data type
40021 Master / Slave mode unsigned int.
40022 Temperature setpoint unsigned int.
40023 CO setpoint unsigned int.
2
40024 Air quality setpoint unsigned int.
40025 Pressure setpoint unsigned int.
40026 Relative humidity setpoint unsigned int.
40027 Heat / Cool mode unsigned int.
40028 Disable / Enable PI control unsigned int.
40029
40030 PI control Kp value unsigned int.
40031 PI control Ti value unsigned int.
40032
40033 Display mode unsigned int.
40034 Output overrule timer unsigned int.
40035-
40040
Note: Les registres de maintien (HOLDING) peuvent êtregérés via les commandes Modbus suivantes "Read Holding Registers", "Write Single Register" ou "Write Multiple Registers".
Pour en savoir plus à propos de Modbus sur liaison série, s'il vous plaît visitez:
MIW-RDCV-FR-003 - 28 / 07 / 17
Description
Selection of device operating mode
Temperature setpoint in Master mode
CO setpoint in Master mode
2
Air quality setpoint in Master mode (Sets the content of air
pollutants in kppm)
Pressure setpoint in Master mode
Relative humidity setpoint in Master mode
Output mode selection
Disable / Enable PI control calculation for output
Reserved, returns "0"
Set proportional gain for PI control
Set integrator time for PI control
Reserved, returns "0"
Display input / output value selection
Set overrule timer in case output value has been changed
manually
Reserved, return "0"
http://www.modbus.org/docs/Modbus_over_serial_line_V1_02.pdf
www.sentera.eu
www.atib.fr
Retour à la Table des matières
Mode automatique (maître)
Data Default Values
0 =
0—1 0
1 =
0—700 200 200 =
0—2000 700 700 =
0—2000 700 700 =
0—2000 100 100 =
0—1000 400 400 =
0 =
0—1 0
1 =
0 =
0—1 0 1 =
50 =
0—100 20
20 =
50 =
0—100 20
20 =
0 =
0—1 0
1 = Show controller output value
10 =
10—1440 10
1440 =
Slave mode
Master mode
20,0 ºC
0,70 kppm
0,70 kppm
0,10 kPa
40,0 %
Heat
Cool
Enable
Disable
5,0
2,0
5,0
2,0
Show sensor input value
10 min
24 h
16 - 17
16