Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
M1.1.CAT30DP.NLFREN 21062018
EN
5 Lifting
1. Prior to operating the jack, remove any accumulated air from the system:
Pull the handle and turn in counterclockwise whilst held in this position, pump the jack several times to ensure internal
lubrication and bleed the accumulated air from the system.
2. Refer to the vehicle manufacturer owner's manual to locate the approved lifting points on the vehicle. Center the jack saddle
under the lift point.
3. This jack is fitted with a foot pedal that gives a faster approach to the load.
4. Pump handle full stroke until the load reaches the desired height.
5. Transfer the load to appropriately rated jack stands.
6 Lowering
1. Raise the vehicle and clear the jack stands.
2. Pull up the handle and turn it counterclockwise. The handle is self-return (dead man principle), you need to hold the handle
until the jack is back to the initial position.
7 Maintenance
•
Both the maintenance and repair of the jack may only be performed by qualified professionals.
•
Only original spare parts should be used.
•
When not in use, store the jack with saddle fully lowered. Keep the jack in a clean, dry place and out reach of children.
•
If the oil level needs to be checked or refilled, remove the filler plug and drain it's contents into a container. Make sure that
no dirt enters with the new oil.
•
Too much oil will prevent saddle from lowering completely. Not enough oil and saddle will not be able to rise to full height.
•
Do not use brake fluid, turbine oil, transmission fluid, motor oil or glycerin. Improper fluid can cause permanent failure of
the jack and the potential for sudden and immediate loss of load. Premium hydraulic jack oil is recommended.
Oil plug
7
Publicité
Table des Matières
