Connecting The Attachment To The Upper Shaft; Removing The Attachment From The Upper Shaft; Attaching The Front Handle - Toro 51958 Manuel De L'opérateur

Connecting the Attachment to the
Upper Shaft
See Figure 2.
WARNING:
Never install, remove, or adjust any attachment
while power head is running. Failure to stop the
engine can cause serious personal injury. Never
operate power head without an attachment.
WARNING:
operating equipment; check it periodically for
tightness during use to avoid serious personal
injury.
coupler device. Follow these steps to connect the attachment
to the upper shaft.
1. Stop the engine and disconnect the spark plug wire.
2.
3. Remove the end cap from the attachment shaft.
4.
pler and slide the two shafts together. Rotate the attach-
hole.
Note:
positioning hole, the shafts are not locked into place.
locked into place.
5.
Coupler
Guide
Recess
Button
Attachment
Shaft
12
Removing the Attachment from the
Upper Shaft
See Figure 2.
Follow these steps to remove the attachment from the upper
shaft.
1. Stop the engine and disconnect the spark plug wire.
2.
3.

Attaching the Front Handle

See Figure 3.
Follow these steps to attach the front handle.
1. Press the front handle onto the top of the upper shaft, in
2. Place the front handle along the upper shaft to a posi-
3.
4. Align the hole in the front handle with the hole in the
5.
Note:
-
the front handle.
Power
Head Shaft
Tab
Knob
Figure 2
the handle toward the throttle trigger.
handle.
handle support.
support. Secure handle in place using wing nut.
Bolt
Slot
Front
Handle
Throttle
Trigger
Handle
Support
Wing
nut
Figure 3
Assembly