Accessories - Whirlpool Gladiator Garageworks Armoire a outils modulaire porte pleine Instructions D'assemblage

Install Leveling Legs or Casters
The Gladiator ® Modular Cabinet is designed to be either stationary or
to roll on casters. See "Assessories" to order the caster kit.
IMPORTANT: If you decide to install the casters on the cabinet, see
the installation instructions included with the caster kit (provided).
To install leveling legs:
1. Place the cabinet on its side.
2. Screw a leveling leg (P7) into each of the four rivet nuts located at
the corners of the cabinet as shown.
P1
P6
A. Leveling legs
3. Stand the cabinet upright.
4. If you have not already, fasten the two bolts at each front corner,
of the cabinet frame. Completely tighten all the cabinet bolts and
nuts.
Install Shelves
F3c
F3c Phillips-head screw (8 - black)
IMPORTANT:
Install shelf (P8m) in the cabinet so that the long edge with
magnets is facing the cabinet front.
Use the pair of holes indicated to install shelf (P8m), so the doors
will lock.
Shelf (P8) may be installed using any of the other pairs of holes in
the cabinet sides.
1. Align the holes in the shelf with the pair of holes shown.
2. Using Phillips-head screws (F3c) and small flange nuts (F5) per
side, fasten shelf (P8m) to the cabinet sides (P1 and P3).
P1
A
A. Holes for installing shelf
B. Slot in shelf for lock
P7
P4
A
F5
F5 Small flange nut (8)
P2
P3
P8m
B
3. Place shelf (P8) so that the holes in the ends are aligned with the
desired set of holes in the cabinet sides (P1 and P3).
4. Using Phillips-head screws (F3c) and small flange nuts (F5) per
side, fasten the shelf to the cabinet sides (P1 and P3).
Install Doors
F3c Phillips-head screw (8 - black)
The door hinges are designed with keyhole slots at the top and
bottom so the door will hang on the cabinet while you are fastening
the screws.
1. Start Phillips-head screws (F3c) in both the top and bottom holes
on each side of the cabinet.
2. Hang the right-hand side door (P10) from the top and bottom
screws, and hand tighten.
3. Insert the middle two screws through the door hinge into the
cabinet and hand tighten.
A. Phillips-head screws (F3c)
4. Repeat steps 2 and 3 to attach the left-hand door (P9).
5. Align the doors and completely tighten the screws.
Complete the Assembly
1. Make sure there is a bolt or screw in each hole of the cabinet
frame.
2. Move the cabinet to its final location.
3. If the doors are not aligned, loosen all the screws attaching the
door hinge to the cabinet.
4. Adjust door to the desired height, and fully tighten the screws.

ACCESSORIES

To order the accessories listed below or to inquire about other
available accessories call 1-866-342-4089 or contact your
authorized Gladiator brand dealer.
In Canada, call 1-800-807-6777.
Caster Kit
Order Part # GACK04KDSX
VersaTop™ Work Surface
Order Part # GAVT18SPSX
Modular Bamboo Top
Order Part # GAAC28BAYX
F3c
P2
P8m
P8
P9
P4
A
5