Assemble Cabinet; Attach Back Panels - Whirlpool Gladiator Garageworks Armoire a outils modulaire porte pleine Instructions D'assemblage

Assemble Cabinet

F1
⁵⁄₁₆
F1 " Internal hex head bolt (24)
⁵⁄₁₆
F2 " Flange nut (8)
Gather the required tools before starting installation.
Tools Needed:
¹⁄₂" Wrench
³⁄₈" Wrench
¹¹⁄₃₂" Wrench
Tools Supplied:
Hex key
WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet.
Failure to do so can result in back or other injury.
IMPORTANT:
Two people may be required to complete the assembly.
As you assemble the cabinet, make sure the edges with the
holes are facing up.
If you are assembling the cabinet on the floor, fasten the eight
front corner bolts, two at each corner, after you stand the cabinet
upright.
1. Place side panel (P1) on a flat, firm surface so that the edge with
the holes is facing up as shown.
2. Insert the cabinet top (P2) between the edges of side panel (P1).
NOTE: Make sure the edges with the holes are facing up.
3. Align the holes and attach the top (P2) to side panel (P1) using
six internal hex head bolts (F1) and two ⁵⁄₁₆" flange nuts (F2) for
the two middle holes only, as shown. Do not tighten completely.
4. Position side panel (P3) so that the top (P2) is between the edges
of side panel (P3).
5. Align the holes and attach the top (P2) to the side (P3) using six
internal hex head bolts (F1) and two ⁵⁄₁₆" flange nuts (F2) for the
two middle holes only, as shown. Do not tighten completely.
6. Insert cabinet bottom (P4) between the edges of side panels
(P1 and P3).
NOTE: Make sure the edges with the holes are facing up.
4
F2
Phillips screwdriver
Pliers
Level
Key
7. Align the holes and attach the bottom (P4) to the side panels
(P1 and P3) using six hex-head bolts (F1) and two ⁵⁄₁₆" flange
nuts (F2) for the two middle holes only, for each side as shown.
Do not tighten completely.
P1
P2

Attach Back Panels

F3c Phillips-head screw (16 - black)
1. Align lower back panel (P6) with the holes in the cabinet
bottom (P4). Using Phillips-head screws (F3c), attach back panel
(P6) to the bottom (P4) and sides (P1 and P3) as shown. Do not
tighten screws completely.
2. Align upper back panel (P5) with the holes in the cabinet top (P2).
Using Phillips-head screws (F3c), attach back panel (P5) to the
top (P2) and sides (P1 and P3) as shown. Do not tighten screws
completely.
NOTE: Upper back panel (P5) will slightly overlap lower back
panel (P6).
3. Using Phillips-head screws (F3c), attach the upper back panel
(P5) to the lower back panel (P6) as shown.
4. Completely tighten all back panel screws starting with the sides
and continuing with the top, middle, and bottom.
P3
P4
5. Using the hex key (provided), completely tighten all the cabinet
bolts and nuts.
P4
P3
P2
F3c
P5
P2
P6
P1
P3