Use; Device Overview; Operation - Intenso B1 Notice D'utilisation

USE

Device overview

2 - IN

Operation

1. LED Status display
The actual operating condition of device will be displayed by the status LED. The LED will turn
green when the charge procedure starts. If the LED is switched off, the charge procedure is
concluded or there is no Qi-compatible terminal to be charged on the inductive charge station.
If the LED flashes green, there is an error, for example because the device has become warm, a
foreign body is between the devices or a non-compatible adapter is used.
2. Starting-Up / Charging Connected Devices
Step 1: Preparation
Connect the supplied microUSB cable with the microUSB connection (IN) of the inductive charge
station and connect the other USB cable end with a USB adapter. Then connect the adapter with
a socket (by complying with the safety instructions mentioned above).
Step 2: Start charge procedure
Position your Qi-compatible device in the middle on the inductive charge station. The charge
procedure starts automatically and the status LED turns green.
If this is not the case, please check (if):
a) There is a foreign body between the devices.
b) You have selected a compatible adapter.
c) Your device is Qi-compatible.
d) The cable ends and the adapter are connected correctly.
e) Where there is the correct position on your device for the wireless charge. In case, you
must change position.
Step 3: Complete charge procedure
To complete the charge procedure, simply remove your device from the inductive charge station.
EN - Page 3 of 6
1 - Status LED