4. Use / Operators
4.1 Intended use
This controller is used for the LAMBDA Electric cylinder and LAMBDA Colonne drives. Up to three
drives can be connected to the LBG controller and LBS controller.
Intended use of the controller includes electromotive adjustment of moving furniture com-
ponents or comparable items.
Generally, use must be restricted to dry rooms and it should not be used outdoors.
4.2 Improper use
"Improper use" means that the information given in section Intended use is not being observed.
In the event of improper use, incorrect handling or if this controller is used, installed or handled by
untrained personnel, this controller may pose risks for personnel.
Moving personnel with this controller is an example of improper use and is prohibited.
In event of improper use, Phoenix Mecano Komponenten AG is no longer liable for this controller
and its general operating licence will expire.
4.2.1 Reasonably foreseeable misuse
•
Controlling unsuitable drives
•
Overloading appropriate drives
•
Exceeding the duty cycle of the controller or drives
•
Operation with damage to the mains supply, housing, motor lead, hand switch or other
control lines (PLC, PC, etc.)
•
Operation with the controller housing open
•
Use outdoors
•
Use in an environment with high air humidity > dew point
•
Use in an atmosphere containing solvents
•
Contact with paints containing solvents
•
Use in an environment in which it can be expected that combustible and explosive gases or
vapours might be present
•
Failure to comply with the rated voltage as given on the maker's plate on the controller with
a maximum tolerance of +/- 10 %
•
Failure to comply with the upper and lower ambient temperatures: +5 deg. Celsius/+60 deg.
Celsius
4.3 Who is authorised to use, install and operate this controller
Anyone who has read and understood the assembly instructions may use the controller. Respon-
sibilities in use must be clearly defined and observed.
22