Preparing The Battery Charger; Lifting And Transporting The Machine; Practical Guide For The Operator; Controls - Description - Alfa A780 Manuel D'instructions

Use CE-marked battery chargers that comply with the relevant product standards
(EN60335-2-29), featuring double or reinforced insulation between input and output,
and a SELV output circuit

5.5.2. Preparing the battery charger

If you wish to use a battery charger not provided with the machine, you must fit it with the
connector supplied with the machine.
The connector supplied for the external battery charger is suitable for cables with a
minimum cross-section of 4 mm
To install the connector, proceed as follows:
•
remove about 13 mm of protective sheath from the red and black wires of the
battery charger;
•
insert the wires into the connector contacts and squeeze them forcefully with
suitable pliers;
•
respect the polarity (red wire + black wire -) when inserting the wires into the
connector.
•
Insert the wired-up connector into the connector on the machine (fig. C, ref. 4).
5.6.

Lifting and transporting the machine

All phases must be performed in an adequately lit room and adopting the safety
The operator must always use personal protection devices.
To load the machine onto a means of transport, proceed as follows:
• empty the collection and solution tanks;
• remove the squeegee and brushes (or abrasive disks);
• remove the batteries;
• place the machine on the pallet and fix it with plastic straps or metal brackets;
• lift the pallet (with the machine) using a fork lift truck and load it onto the means of
transport;
• anchor the machine to the means of transport with cables connected to the pallet and
machine itself.
6.
6.1.

Controls - Description

These terms have the following meanings:
STANDARD MACHINE, version of the machine designed for use with brushes or
abrasive disks.
MICRO SCRUB / ECS MACHINE, version of the machine designed for use with
microfibre disk, brushes or abrasive disks.
With reference to fig. A, the machine has the follow controls and indicator lights:
•
Battery charge light (fig. A, ref. 5): 4 LEDs, which indicate the level of battery charge
(see paragraph 6.9)
•
Main Switch (fig. A, ref. 1): enables and disables the electrical power supply to all
machine functions.
•
Emergency button (fig. A, ref. 10): acts as a safety device.
ENGLISH
12
! DANGER
2
 IMPORTANT
measures most appropriate to the situation.

PRACTICAL GUIDE FOR THE OPERATOR