Alecto COA4010 Mode D'emploi page 39

AVOID THE FOLLOWING PLACES FOR INSTALLATION:
• Do not install the CO-detector in the turbulent air created by ceiling fans.
• Do not install the CO-detector near vents with fresh air.
• Do not install the CO-detector near doors and windows leading outdoors.
• Do not install the CO-detector near extremely dusty, dirty or greasy spaces such as heating spaces
<4m³ or pantries. Dust, grease and household chemicals can affect the sensor.
• Install the CO detector at least 0.5 meters away from gas discharge lamps (halogen) because of
electronic interferences that can lead to false alarms.
• Do not install the CO detector in humid and wet spaces, such as the bathroom.
• Do not install the CO detector in a location where the temperature is lower than -10°C or warmer than +40°C.
• Do not install the CO detector in a place where the humidity is higher than 93%RH.
• Never install the CO detector behind curtains or furniture. Carbon monoxide must be able to reach the
sensor to ensure the sensor can properly detect carbon monoxide levels.
• Never install the CO detector flat on a table or similar surface.
• Never install the CO detector in spaces where spray cans may be used (hair spray, deodorant)
INSTALLATION:
1. Install the mounting plate on a suitable spot, using the mounted plugs and screws.
2. Place the COA4010 on the mountingplate. Make sure that the pin on the backside in fitted in the
mounting base. Slide the COA4010 downwards to lock into position on the mounting plate.
3. You can perform the first test by briefly pressing the test button, see also paragraph "Testing".
4. The CO detector is now functional.
Nicht hinter
ein Kabinett
39
Nicht neben
Belüftungs-
öffnung
Nicht hinter
ein Vorhang