Troubleshooting - Jocel JACP-010 Manuel D'instruction

TROUBLE SHOOTING
Never try to repair or dismantle the air condition yourself. Incompetent repairs result in
loss of warranty and can endanger the user and the property.
Problem
The air conditioner
does not function
The air conditioner
does not seem to
perform
The unit is noisy
The compressor
does not work
The remote control
does not function
To correct problems that have not been described in the table and/or if the
recommended solutions fail to solve the problem, contact the Technical Assistance.
Cause
No power supply
Is the power light flashing?
Timer function is active
The unit is in direct sunlight
Windows or doors
many people or
source in the room
The filter is dirty
Air inlet or air outlet blocked
Room temperature
than the selected value
Unit stands unevem
The overheat protection is
probably activated
Distance too great
Remote control signal not
detected by the control panel
The batteries are drained
Solution
Connect a functioning outlet
and switch on.
Empty the drain pan.
Desactivate
function.
Close curtains
open,
Close doors and windows,
a heat
place an extra air conditioner
Clean or replace the filter
Remove the blockage
Change temperature selection.
lower
Set at the lowest possible
setting: 17ºC
Place
surface (less vibration)
Wait
temperature has decreased,
then turn on the unit again
Make sure the remote control
is correctly
control panel.
Replace the batteries
-36-
the TIMER
on an even,
3 minutes until
aimed at
solid
the
the