Installation Instructions; Installation Location - ELRO FC280211 Manuel D'utilisation

Thank you for purchasing the FC280211 carbon monoxide (CO) alarm.
This unit uses advanced electrochemical sensor, and with LCD digital display for CO concentration. Please take a few minutes to
thoroughly read the user manual before operating or servicing and familiarize yourself and your family with its operation. And
save for future reference.
•
Reliable electrochemical sensor
•
Including 2x 1,5V batteries
•
Silence mode
•
Low-battery indicator
•
End-of-life indicator
The alarm should be installed by a competent person. This apparatus is designed to protect individuals from the acute effects
of carbon monoxide exposure. It will not fully safeguard individuals with specific medical conditions. If in doubt consult a
medical practitioner.
CAUTION: This CO alarm is designed for indoor use only. Do not expose to rain or moisture. Do not knock or drop the detector.
Do not open or tamper with the alarm as this could cause malfunction. The alarm will not protect against the risk of carbon
monoxide poisoning when the battery has drained. Installation of the alarm should not be used as a substitute for proper
installation, use and maintenance of fuel burning appliances including appropriate ventilation and exhaust systems.
WARNING! - Do NOT try to repair the device, it has the risk of electric shock or malfunction if the device is tampered with.
We are constantly improving our products and service. Go to
Also check www.elro.eu
you to better understand the product.
1.

INSTALLATION INSTRUCTIONS

1.1

Installation location

When choosing your installation locations, make sure you can hear the alarm from all sleeping areas. If you install
only one CO alarm in your home, install the alarm near bedrooms. Not in the basement or furnace room. The
recommended position for the unit should be at least 1.8 meters (about 6 feet) above the floor level.
CAUTION: This alarm should be installed by a competent person.
1.2 Mounting step
• Drilling two ф5.0mm holes in the wall, the distance between two holes center is 52mm, then inserting two plastic
plugs provided into the holes.
•
Insert the two screws provided until the screw heads are approximately 5mm from wall.
•
Test the unit by using the TEST/SILENCE button. Ensure the unit sound is alarm pattern.
•
Hook the unit over the screws onto keyholes at the back of the unit.
for all relevant frequently asked questions and newest developments for this product. This will help
www.elro.eu to download the latest version of this manual!
- 1 -