Care And Cleaning - Toastess TDF-23 Mode D'emploi

CARE AND CLEANING

1. Unplug cord from wall outlet. Allow oil to cool. NOTE: Oil retains its
temperature for a long time after use. Do not attempt to empty the Fryer
until the oil has cooled completely. Do not move or carry the Fryer while
it is still hot.
2. Once oil has cooled, remove the Lid (see the 'Removing and Replacing
the Lid' section below. Pour the oil into a container that holds at least
3 litres. Place the container in the sink and pour the oil from the Base
by either side of the fryer. Make sure that the fryer is completely empty
before turning the Fryer upright to prevent oil from dripping down the
exterior wall of the Fryer Base.
3. When Base is empty, add about 2 cups (500 ml) of warm soapy water
and let stand for a few minutes. Use a nylon pad or brush to remove
heavy oil stains. Empty. Rinse with about 2 cups (500 ml) of clean water.
Empty and dry. NOTE: Be careful not to let water drip down exterior wall
of Fryer Base.
4. Filter oil through either absorbent paper or a large coffee filter into
another container or back into the cleaned Fryer. Oil should retain its
properties for another 8 - 12 uses. NOTE: If oil has been used for cooking
seafood, it should be discarded.
5. Wipe Lid and exterior wall of Fryer Base with a damp cloth and dry.
6. The Frying Basket and Handle can be washed in hot soapy water.
Rinse and dry.
7. Replace the Lid and place the Frying Basket back in the Fryer.
Store in a cool dry place.
NOTE:
• DO NOT IMMERSE FRYER, LID, CORD OR PLUG IN WATER OR
ANY OTHER LIQUID.
• DO NOT USE STEEL WOOL OR ABRASIVE CLEANERS ON ANY
PART OF YOUR APPLIANCE.
7