Hama Move Mode D'emploi page 5

4.1 Attaching the holder
• Remove the protective film from the suction cup and position it on a clean and flat surface (e.g. window
pane).
• If the suction cup holder is to be attached to a rough or uneven surface, an adapter plate is optionally
available.
• Turn the base of the holder (1) clockwise to attach the suction cup.
• Open the clamping device (2) to position the carrying arm.
• Close the clamping device to lock this position.
• To detach the suction cup from the surface, turn the base of the holder anticlockwise. Then gently pull the
flap to completely release the suction cup. (3)
4.2 Mounting the holder
• Set the recess or recesses of the holder onto the bracket.
• Move the holder up or down until it clicks into place or is seated firmly.
4.3 Inserting and removing terminal devices
Note
Always take your terminal device out of the holder before attaching or removing the bracket (suction cup
holder).
• Pull the holding brackets a little apart to insert/remove your terminal device.
• Insert the terminal device of your choice and secure it in place by lightly pushing the retaining jaws
together.
5. Warranty disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper
installation/mounting, improper use of the pro
7