strapex STM 61 Mode D'emploi page 17

Fig. 5
Fig. 6
Fig. 7
07.12
ca. 1 mm (.039")
Releasing strap tension
In order to release the strap again during the tensio-
ning process:
– Press black tension pawl (5/2) against tensioning
lever (5/1).
– Draw back tensioning lever firmly to disengage the
tension pawls and release the strap tension.
– When the strap tension is reached, move sealing
lever (6/1) to the stop. The right hand remains on
the tensioning lever to resist the opposing force.
The strap is sealed and cut.
– Return sealing lever to initial position.
– Raise the rocker lever against the sealing lever.
– Swivel the tool away from the strapping to the right
at the rear.
– Check the seal (see fig.7).
Never transport or move packaged
goods with incorrectly notched seals.
Check of seal
To obtain the maximum seal efficiency, the notches
have to be cut properly into the straps (interlock). If
these notches are not correctly cut, replace matrice
and die, see chapter 6.6.
Use only original spare parts.
Strapex STM 61
17