Troubleshooting Guide; Replacement Parts - ProctorSilex 51000 Manuel D'utilisation

Care and Cleaning

Troubleshooting Guide

Problem . . .
Blender fails to start
or stops while it is
running and cannot
be restarted
Ingredients will not
mix properly
Maintenance
Inspect the blender and its various parts and replace as follows:
Daily Unplug the blender, remove the container from the base, and then inspect the container
and cutter unit assembly for wear, nicks, and broken or loose blades. Replace if
necessary. If the blades are loose, discontinue use immediately and replace the blades.
Do not attempt to repair or tighten the cutter assembly. See "Replacement Parts" below.
Weekly Unplug the blender, and then inspect the power cord insulation and power plug for
cracks. Refer to "Technical Service" for repair or replacement.
Quarterly Replace the container and cutter assembly at least every 90 days. See "Replacement
Parts" below.
NOTE: The rubber clutch disc on the blender base has reverse threads. To replace, remove the rubber clutch
disc by threading it clockwise. To install the new clutch disc, thread it onto the motor shaft counterclockwise.

Replacement Parts

For replacement parts, call toll-free: 866-285-1087.
Part Description
48-Ounce Container
Cutter Assembly
Rubber Clutch Disc
8
Solution . . .
• Check to see if unit is securely plugged into an electric outlet.
• Check to see if the fuse for the electric outlet has blown or if a circuit breaker
has tripped.
• Check to see if enough liquid has been added to the ingredients. Mixture should
be fluid and free-running at all times.
• Solid pieces are too large. Pieces should not exceed 1" (25 mm) cubes.
• Container is too full. Do not fill past highest graduation marking.
• Cutter unit blades are not sharp or are damaged. Inspect container and cutter
assembly daily. Replace cutter assembly at least every 90 days or sooner if
cutter assembly appears worn or damaged.
• Check to see if cutter assembly is installed properly.
• Select speed to create a fluid blend.
Part Number
55700
98908
990093600