Operating The Blender; Using The Blender - ProctorSilex 51000 Manuel D'utilisation

Operation

Operating the Blender

Controls
The switch on the front panel allows you to control
the blender for precise blending requirements. The
blender is equipped with HI/2 and LO/1. OFF is O.
Select the desired speed by pushing the power
switch up one notch for LO/1 or up two notches
for HI/2.

Using the blender

Before you use the blender for the first time, wash
the container, cover, and cutter assembly. Refer to
"Cleaning Instructions." Do not put the cutter
assembly in the dishwasher.
To operate the blender, proceed as follows:
1. Place the blender on a clean, dry, level surface.
Make sure that the HI/LO/OFF switch on the
control panel is set to OFF/O.
2. Plug the blender into an electric outlet.
3. Place the ingredients to be blended into the
container.
4. Place the container onto the base. Make sure
it rests securely on the base.
HI/LO/OFF Switch
5. Place the cover and filler-cap on the container.
6. Move the HI/LO/OFF switch to the desired speed.
See "Professional Blending Techniques" for
blending tips.
7. When blending is complete, set the HI/LO/OFF
switch to OFF/O.
Do not remove the container from the base
until the unit has stopped completely.
5