Russell Hobbs 20570-56 Mode D'emploi page 67

diagrams
1 cap
2 tube
3 reservoir
4 handle
5 anti-scale cartridge
6 power light
C FILLING
16 Pull the reservoir up and off the body.
17 Turn the reservoir upside down, and unscrew the cap.
18 Lift the cap and tube out of the reservoir.
19 Fill the reservoir with fresh cold water.
, Don't add anything to the water – you may damage the appliance, you will destroy the
anti-scale cartridge.
20 Slide the tube into the reservoir, and screw on the cap.
21 Turn the reservoir right way up, and replace it in the body.
C TILT OR LOCK?
22 The joint where the body meets the base has two positions.
23 Hold the front of the base gently with a foot while changing positions.
24 Push the handle forward to lock the handle/body upright.
25 Pull the handle back to unlock the handle/body, so the base moves freely (like an upright
vacuum cleaner).
C USING THE CARPET GLIDER
26 If you're going to clean carpet, rest the base and cloth in the carpet glider.
27 This will reduce drag, and make moving the mop much easier.
C SWITCHING ON
28 Rotate the top cable hook, and remove the cable from the hooks.
29 Push the body end of the cable into the pinch in the tip of the top cable hook, to help keep it
out of your way.
30 Put the plug into the power socket.
31 The power light will glow as long as the appliance is connected to the electricity supply.
32 The thermostat light will glow when the appliance reaches working temperature.
33 It will then cycle on and off as the thermostat operates to maintain the temperature.
C IN USE
34 Wait till the thermostat light glows.
35 Unlock the handle/body to allow the base to move freely.
36 Hold the appliance by the handle. Press the trigger to produce steam, release it to stop.
37 Move the appliance over the floor, cleaning a small area at a time.
38 When you change areas, overlap the previous area, to avoid missing anything.
C CARE AND MAINTENANCE
39 Unplug the appliance and let it cool.
40 Remove and empty the reservoir.
41 Remove the anti-scale cartridge and tip any residual water out of it.
42 Replace the cartridge and the reservoir.
43 Wipe outer surfaces with a damp cloth.
44 Untie the ties, and remove the cloth from the base.
45 You may wash the cloth by hand, or in a washing machine at the 40° setting.
, Don't use bleach.
, Don't use fabric softener.
7 thermostat light
8 trigger
9 pinch
10 cable hook
11 shaft
12 pip
13 body
67
14 screw
15 base
16 cloth
17 ties
18 carpet glider
19 steam valve
[