Dexter 82890148 Mode D'emploi page 38

FR Do not rotate the winch crank any longer, when the indicator situated at the bottom of the column appears.
THE FOLLOWING IS FORBIDDEEN:
Do not use the panel lifter DEXTER®:
- Beyond the maximum use load (65 kg)
ES
- Beyond the maximum fixing height, according to the adjustment chosen
for the head tube
- Do not remain under the load.
PT
When using the panel lifter DEXTER®, comply with the work hygiene and safety
rules.
C - MAINTENANCE OF THE PANEL LIFTER DEXTER®
IT
1) General maintenance
EL
Check the following parts at regular intervals, according to the indications given in the table below:
PARTS
PL
The condition of the cable, pulley and pulley
pin,
RO
The condition of the rubber stops and shoes,
EN
The conditions of the wheels and the opera-
tion of the wheel brakes,
The fixing and clamping devices
The cleanness of the columns,
The effectiveness of the fall prevention system
(see §2)
The condition of the winch and its function
(see § 3)
The condition of the head and its function
(see § 4)
And replace if necessary.
Any defective cable must be replaced by a guenuine cable
(Characteristics of the cables: diameter 3 mm, composition: 7 x 19 wires, actual breaking load: 5.75 kN)
2) Fall prevention system
Check the effectiveness of the fall prevention system (with no load) at intervals, hold the cable with your hand
(glove), slacken the cable with the crank and release the cable. The device must remain locked. To release the
cable, operate the winch in the "Up" direction.
3) Maintenance of the winch
The winch requires regular servicing by a competent department. Regular cleaning
makes for a longer service life.
- Never work with a defective cable.
- Keep the pinions, bearings and reel pin well greased. Use a Molydal N° 3790 type
grease.
- Keep the winch in good operating condition. Non-serviced mechanical parts can
cause operating problems or even accidents.
- During the lifting operation the operator should hear a regular "click"-sound
coming from the winch. This is an indicator of the good functioning of the winch. In case
the sound is inaudible it might be possible that the load brake is not engaged. Turn the
handle 2 or 3 turns in the "up" direction to engage the brake system. If the sound is still
inaudible after a couple of turns, do not use the winch.
4) Maintenance of the head:
The head requires cleaning at intervals.
Keep the pawl pin well greased.
Use a paraffin oil
FREQUENCY
Week Month Visual check
X
X
X
X
X
X
X
X
38
Indicator for max. extension
of the column
TYPE OF VERIFICATION
Test Lubrication
X X
X
X X
X
X X
X
X X
X X
Molydal N° 3790
Molydal N° 3790
X
X