Boiling The Water; Setting The Water Temperature - T-Fal THERMOVISION KI410 Mode D'emploi

BOILING THE WATER

Press The On/Off Button (C).
• The button will light up.
• The heating cycle starts.
• When the water is heating, the temperature of the water in the kettle is
displayed on the digital panel.
• The light inside the kettle changes colour according to the temperature of
the water (green>cyan>blue>violet>red).
• When the water boils, a beep sounds and the kettle is switched off
automatically.
Note:
You may interrupt the heating cycle at any time by pressing the on/off
button or by removing the kettle from its base. do not leave water in the
kettle after use.

SETTING THE WATER TEMPERATURE

This electronic kettle allows you to heat water to the desired temperature. In
order for the temperature displayed on the panel to be as accurate as possible,
fill your kettle with at least 0.5L of water.
Press the "temperature setting" button (E) several times to display the
various temperatures (160°F – 175°F – 185°F – 195°F) and stop at the
desired temperature.
• A red dot lights up below the selected temperature and the selected
temperature flashes on the panel.
• The heating cycle starts and the water level lights up. Each temperature
selected corresponds to a colour of light: cyan for 160°F, blue for 175°F, violet
for 185°F and red for 195°F.
• When the water is heating up, the temperature of the water is displayed on
the digital screen.
Note:
The pre-selected temperature may be modified at any time by pressing
the "temperature setting button" (E) several times to choose the new
temperature.
The heating cycle may be stopped at any time either by removing the
kettle from its base or by pressing the "temperature setting button" (E)
several times until it switches off.
• When the water reaches the pre-selected temperature, a beep sounds.
• A warm cycle will start automatically. The water will be kept at the selected
temperature for 30 min.
8