Before Using For The First Time - T-Fal THERMOVISION KI410 Mode D'emploi

• Remove all of the various packaging, stickers or accessories from both the
inside and outside of the kettle.
• Adjust the length of the cord by winding it under the base. Wedge the cord
into the notch. (fig. 1)
• Throw away the water the first two or three times you use the kettle, as
it may contain dust. Rinse the kettle and the filter separately.
Use
1. TO OPEN THE LID:
• Pull the lid locking system and it will lift up automatically (fig. 2).
To close it, press the lid down firmly.
2. PLACE THE BASE ON A FLAT, SMOOTH, CLEAN HEAT
RESISTANT SURFACE.
• Your kettle must only be used with the base that it is delivered with and its
own anti-scale filter.
3. FILL THE KETTLE WITH THE DESIRED AMOUNT OF WATER.
(FIG. 3).
• You can fill it through the spout, which ensures better maintenance of the
filter.
• Never fill the kettle when it is on its base.
• Do not fill it above the maximum level, or below the minimum level. If the
kettle is too full, boiling water may spill out.
• Do not use without water.
• Check that the lid is closed properly before use.
4. POSITION THE KETTLE ON ITS BASE. (FIG. 4). PLUG IT INTO
THE MAIN SOCKET
When the kettle is plugged in, a beep sounds and the display lights up.
The temperature of the water is only displayed above 104°F, otherwise "LO"
is displayed on the panel.
Familiarise yourself with the control panel and the various functions of the
kettle by referring to figure 6 (fig. 6):
A. Luminous red dot which shows the temperature selected
B. Digital panel: displays the current temperature (in degrees Fahrenheit)
C. ON/OFF button
D. Boiling cycle
E. Temperature setting button: 160°F – 175°F – 185°F – 195°F with keep hot
function on

Before using for the first time

EN
7