Before Every Use; Switching On And Off; Sucking Up Liquids - CS Unitec CS 1445 Mode D'emploi

5
4

4.1 Before every use

Make sure that the following conditions are met:
Vacuum cleaner, mains cable, suction hose and accessories
are not damaged.

4.2 Switching on and off

The plug socket on the vacuum cleaner remains always under
voltage, regardless of the main switch position.
Danger of injury by automatically starting power tool!
Switch off power tool or pneumatic tool before connecting to
the vacuum cleaner.
cleaner can be used as an extension cable.
Power consumption: vacuum cleaner + connected power
4.2.2 Switching on the vacuum cleaner
Functions see „3 Display and control elements" on page 24.
Insert plug into plug socket.
or:
4.2.3 Setting the suction hose diameter*
Set suction hose diameter at the switch.
light) on vacuum cleaners with dust classes „M" and „H"
depending on the diameter of the hose:
Selector switch for
suction hose inner diameter
35 mm
27 mm
21 mm
The speed can be adjusted individually after setting the hose
diameter.
4.2.4 Adjusting the suction power*
Adjust motor speed on the switch.
or
* depending on model
1-800-700-5919 (US/CA)
Commissioning
WARNING!
NOTE
Vacuum cleaner starts immediately.
Vacuum cleaner is in standby mode for power tools.
CAUTION !
70 l/s
41 l/s
25 l/s
WWW.CSUNITEC.COM
Set auxiliary air slide on the handle tube.
4.2.5 Switching off the vacuum cleaner
Vacuum cleaner is switched off.
After switching off, pull the mains plug out.
Roll up mains connection cable.
Store the mains connection cable on the cable hook.
Store the suction tube by inserting it into the accessories holder*
on the container rear wall.
Put the suction hose ends together so that no dirt particles leak
out.
Remove Power tool.
5 Operating modes
5.1 Sucking up dry materials
the dust does not stick and or cake.
When vacuuming soot, cement, plaster or similar dusts: Insert a
PE disposal bag in the dirt container.
cartridges.
preferably used as vacuum cleaners for dry dusts.

5.2 Sucking up liquids

vacuum cleaner.
and inspect for signs of damage.
The built-in sensor switches the motor off when the container is
full. The handling of the vacuum cleaner can be compromised
by a full container.
info@csunitec.com
NOTE
WARNING!
NOTE
+1-203-853-9522 (Intl.)