Display And Control Elements - CS Unitec CS 1445 Mode D'emploi

4
Read the operating manual carefully before starting to use the vac-
uum cleaner. The operating manual provides important instructions
for safety, commissioning, operation, maintenance and care. Keep
the operating manual in a safe place and, in case you sell the unit,
hand it on to the next owner.
Do not perform any other work than described in this manual.
This machine is intended for commercial use, for example, in
business.
When unpacking, check for completeness and transport damage.
Before use, the operators should be provided with information,
instructions and training for the use of the vacuum cleaner and the
3
Switch position
0
A
AR
IR
1-800-700-5919 (US/CA)

Display and control elements

Function
Vacuum cleaner is switched off
Vacuum cleaner is switched off
Standby mode
Vacuum cleaner starts immediately
Fill level indicator*
Setting the suction hose diameter*
Setting the motor speed*
= 40 %
= 100 %
WWW.CSUNITEC.COM
substances that it is to be used for, including the safe procedure for
the removal of the gathered material.
Description
- Plug socket under voltage
- Plug socket under voltage
-
- When the tool is switched on, the vacuum cleaner automatically
switches on. After the power tool is switched off, the vacuum cleaner
runs on for approx. 10 seconds to prevent any residue from collecting
in the hose
- Plug socket under voltage
-
differential pressure detection
- When the tool is switched on, the vacuum cleaner automatically
switches on. After the power tool is switched off, the vacuum cleaner
runs on for approx. 10 seconds to prevent any residue from collecting
in the hose
- Plug socket under voltage
-
detection
-
are cleaned alternately when a certain negative pressure value is
-
acoustic signal is also emitted
-
trigger an audible warning signal if the air speed falls below 20 m/s
- Adjust the suction power with the speed control
info@csunitec.com
* depending on model
+1-203-853-9522 (Intl.)