How To Start - LiteHawk CRUSHER MT Manuel D'instructions

LITHIUM Battery and Charger Instructions:
Your New LiteHawk comes with a rechargeable LITHIUM 9.6 Volt battery. This battery
powers the vehicle.
Please read the following information before using your new LiteHawk.
STEP 1: Remove the wall plug charger from the package and plug it into the wall. When
plugged in a green LED light will come on.
STEP 2: Connect the 9.6 Volt battery to the charger. The green LED light will turn to red.
STEP 3: When the LED indicator light on the charger turns back to green, the battery is
fully charged.
Charge times are (2-2.5 hrs) do not leave on charge overnight. Battery should be
unplugged from the charger after a maximum 8 hours.
STEP 4: Unplug the battery from the charger and remove the charger from the wall plug.
STEP 5: Install battery into your vehicle.
During charging:
- It is normal for the battery to get warm during the charging process. Do not charge the
battery on a surface that is flammable or can be damaged by heat.
- Do not leave the battery and charger unattended while charging.
- Do not store the battery plugged into the charger
Installation of battery into the CRUSHER MT:
Place your CRUSHER MT on a clean flat
surface. Avoid areas where small parts may
be lost. The battery is housed in the battery
compartment located in the top of the chas-
sis. You will see 4 turn tabs or posts that hold
the cover in place.
- Turn the tabs, open the battery compart-
ment door.
- Place your fully charged battery in the bat-
tery slot. Connect the battery connector.
Don't force it, it only goes one way!
- Close the battery compartment door and
turn the tabs back into place.

How to Start!

LiteHawk CRUSHER MT is ready to use - however you must follow
these steps carefully:
1. Switch ON the transmitter.
2. Plug in the battery in the CRUSHER MT.
3. Turn the CRUSHER MT power switch ON.
Power Button