LiteHawk CRUSHER MT Manuel D'instructions page 4

LiteHawk CRUSHER MT - Controller Functions
Steering: The steering wheel controls the
model's direction. Turn the wheel left to
steer to the left. Turn the wheel to the
right and the model will steer to the right.
The steering is 100% proportional and will
react to even slight
inputs. The radio is
designed to self-cen-
tre. Simply release the
wheel from a steering
input and it will go
straight.
Throttle: Forward
drive is initiated by
pulling the throttle
trigger towards the
grip or handle like a
trigger. The throttle
is 100% proportion-
al and will react to
even slight input.
Release the trigger
to slow and stop the
model.
Brake/Reverse: To initiate the brake you simply push the trigger away from the grip just
past the neutral position. You will notice the model will stop much quicker. By pushing the
trigger away from the grip a second time, reverse will be activated.
LiteHawk CRUSHER MT - Battery & Charger
Your LiteHawk CRUSHER MT comes with an 9.6 Volt LITHIUM battery and a 120V wall
mount charger.
Battery:
The rechargeable battery provides the power to propel your model at high speeds. You
should expect 5-8 min run time. Extra batteries are available at www.litehawk.ca.
- Once the model starts to slow, drive your model to a safe place, walk over and turn it
off.
- Never dead short a LITHIUM battery!
- You Must FULLY charge the battery before using your new model.
- Do not leave the battery plugged into the model when it is not being used.
- Keep the battery dry at all times.
Power Button
Steering trim: Steering Trim – Run your
CRUSHER MT on a smooth level surface -
your model should drive straight.
- If your model steers to the RIGHT, turn
the trim wheel LEFT a few times until your
model runs straight.
- If your model steers to the LEFT, turn the
trim wheel RIGHT a few times until your
model runs straight.