Publicité
Les langues disponibles
Les langues disponibles
• Check periodically (at least once a year) the smooth operation of the safety valve;
• In Accumulations of DHW always install a passive cathodic protection (magnesium anode) or active (impressed
current anode) and check periodically, at least twice a year, wear sacrificial magnesium anode or the presence of
power supply on the anode impressed current; an anode of magnesium consumed more than 60% should be
replaced;
• In storage heaters Combined with DHW storage Interior always check during the filling phase, operating and
emptying, that the pressure of the puffer exterior is always lower than that of the accumulation inside;
• In the phases of maintenance and cleaning of kettles with removable tube bundle, make sure that during the
reassembly of the exchanger are present in the cylinders insulating perimeter holes of the tubesheet that host the
passage of fixing screws;
• Check before commissioning the hydraulic seal of the connections and hatch (it is advisable to check the tightness
of the screws hatch after two hours of operation at the maximum temperature);
• In case of use of an electric resistance immersion test this has a communications thermostatic control and an
overtemperature protection, and that it is used the appropriate connection on the kettle; the electrical resistance
must be connected to the earth system.
WARRANTY CONDITIONS
The manufacturer grants a warranty only for defects in material and workmanship on the boilers of its production
under normal installation, use and maintenance of the product claimed.
The warranty is void if failure to respect the installation specifications listed above under "RULES OF INSTALLATION
AND MAINTENANCE".
If the user or installer detects technical problems or functional product purchased, you must immediately contact the
Local Retailer; it is recommended not to perform actions without the permission of the manufacturer or its dealer
direct as possible tampering or repair could void the warranty.
The warranty period begins from the date shown on the delivery evidence by a serial number printed on the label of
the tank. This term does not extend it is renewed as a result of an intervention of warranty replacement. The warranty
period is shown on the label of each product. For accessories and items for the general, for which not expressly
specified (hydraulic units, removable exchangers, etc.), The warranty period of two years except for electrical and
electronic devices for which the duration is one year. It is not covered by warranty accessory parts subject to natural
wear such as screws, gaskets, wells, probes, anodes, thermometers, etc.
The manufacturer does not cover any costs for any direct and / or indirect damages resulting from defects found it
costs related to removal of defective products and installation of replacement products.
Who receives the goods are always required to verify the integrity of the product and compliance to 'order, any
disputes must be noted on the transport document in the presence of the carrier and notified in no later than eight
days from receipt of goods.
6
Rev. 3, 02/02/2016
Publicité
