Q & A - Panasonic AU-XPD1 Mode D'emploi

Q & A
■ The access indicator blinks rapidly in red, and the P2 drive does not work.
Use the supplied USB cables to connect the USB 3.0 connector (SIGNAL) to
the USB port on your personal computer, and connect the USB 3.0 connector
(POWER) to the USB port on the supplied AC adaptor. If the USB 3.0 connector
(POWER) is not connected or is connected to a USB 2.0 port, the access
indicator will blink rapidly in red.
■ The personal computer does not recognize the P2 drive when it is
connected with the two USB cables.
If they are connected to USB 2.0 ports or USB 1.1 ports on the personal
computer, reconnect them to USB 3.0 ports.
If the USB cables are longer than 1.0 m (39-3/8 inches), reconnect using the two
supplied 1.0 m (39-3/8 inches) USB cables.
Do not use bus-powered USB hubs but self-powered USB hubs (self-powered
hubs supply their own power via an AC adaptor).
■ Cards other than P2 cards cannot be used.
The P2 drive is designed for P2 cards and does not support cards other than P2
cards.
■ P2 cards cannot be accessed after resume from sleep or hibernation.
Some personal computers may not be able to access a P2 card in the P2 drive
after resuming from sleep or hibernation. Should this happen, reconnect the two
USB cables.
■ The access indicator blinks slowly (about 1-second intervals) in red and
does not turn off.
The fan requires replacement. Contact your dealer for more information.
■ The fan does not spin.
The fan only spins when the P2 drive's internal temperature is high.
E-13