Panta Safe Guard M23696 Mode D'emploi page 7

• The beam of light may not be directed towards the eyes. Do not use the
product for examining the eyes (examination of the pupils).
• Do not use light-bundling instruments in combination with the product.
Do not short-circuit the contacts of the product.
• Do not attempt to exchange the LED lamp. The LED cannot be
exchanged. In case of damage, always safely dispose of the lamp.
• Contains sharp blades. Always be careful when using objects with sharp
ay
blades.
s is
• The battery included is a premium lithium-ion battery that is designed
for optimal performance. Do not replace the battery with a standard
battery (carbon zinc) or a rechargeable nickel-cadmium battery.
y
• The product is not suitable for room lighting in the home.
ure
Charging the flashlight
st
1. Connect the micro USB cable to the micro USB charging port
2. Connect the standard USB end of the cable to a USB power port on a computer or other charging source.
3. A red light indicates that the device is charging. The light turns green as soon as the device is fully charged.
Important: Fully charge the batteries via the USB port before use.
Using the flashlight
1. Press the „Flashlight / Flash Mode" button to cycle through the following modes.
le
• The first press turns the flashlight mode on
• The second press turns the flashlight mode off
• The third press turns the strobe mode on
of
• The fourth press turns the strobe mode off
2. Move the flashlight's telescopic head forward for a narrow, focused beam and backward for a wider beam.
3. To cut a safety belt, place the safety belt in the notch (Fig. 10) and quickly pull back the commando lamp to cut.
4. To use the emergency signal (Fig. 13), press the power button and switch to strobe mode. Place the
commando flashlight on a flat surface by the roadside.
ns
3696_Panta Safe Guard_Manual_20211005_MM.indd 7 3696_Panta Safe Guard_Manual_20211005_MM.indd 7
7
Made in China
05.10.21 10:0 05.10.21 10:0