Mx Onda MX-PB2443 Manuel D'instructions page 23

This device is designed for home use only. In case of professional use,
improper use or non-compliance with the instructions, the manufacturer
accepts no responsibility and the guarantee will be invalid.
If the appliance has been dropped or if it does not work properly, refrain
from using it and do not attempt to disassemble or repair it. Contact your
nearest MX ONDA Technical Service Center or distributor.
PREPARATION
This device uses two batteries of 1.5 V type AAA, for the placement or
replacement of the same follow the following steps:
1. Remove the lid of the battery compartment located at the base of the scale,
press the tab in the direction indicated by the arrow.
2. Insert two 1.5 V AAA batteries, respecting the indicated polarity.
3. Replace the battery compartment cover.
HOW TO USE
1. Turn on the scale by momentarily pressing the ON / OFF-TARE button.
2. If the scale display shows "UNST" it is an indication that the scale is located
on an unstable surface, so you must move it so that the four sensors are
correctly aligned.
3. With the scale on, press the selector button of the UNIT weight unit, each
time you press this button the weight unit will change kg (kilograms), lb
(pounds) or st (stones).
4. When the display shows the digits "000" it will be an indication that it is
ready, place the baby gently on the scale, and the screen will show the
reading of the weight.
5. If you want to put on the scale a blanket or a moises, before placing the
baby you must press (with the scale on) momentarily the ON / OFF - TARE
button, to discount the added weight of the blanket or moises, the screen
will momentarily show the "Tare" indication.
6. To turn off the scale, press and hold the ON / OFF-TARE button for 3
seconds. However, if you spend 20 seconds without touching any button
and without weighing, the scale will turn off automatically.
Notes:
When the weight limit of the scale is exceeded, the display will show the
overload indication "O-Ld".
If at the end of the weight measurement, the scale shows the indication
"----", it will be an indication that the scale is not correctly leveled, change
its position and momentarily press the ON / OFF-TARE button.
3