emerio SJ-108176 Mode D'emploi page 13

SJ-108176
PARTS DESCRIPTION
1. Food chute
2. Handle
3. On / off / reverse switch
4. Motor base
5. Cleaning brush
6. Food pusher
7. Hopper
8. Auger
9. Strainer
10. Strainer holder
11. Juice bowl
12. Pulp spout
13. Juice spout
14. Juice cup
15. Pulp cup
16. lid
BEFORE FIRST USE
Carefully wipe the exterior of the appliance to remove any dust that may have accumulated. Dry with a dry
towel. Do not use harsh abrasive cleaners.
Remove any label or stickers. Wash the accessories in warm soapy water, dry with a dry towel. Do not
immerse the supply cord or motor part of this appliance in water or any other liquids.
Wash the juicing bowl, strainer, strainer holder, auger, hopper, food pusher, juice cup and pulp cup in warm
soapy water with a soft cloth or nylon brush. Rinse and dry thoroughly.
ASSEMBLY
Before you assemble the juicer, ensure that the power cord is unplugged.
1. Place the motor base on a flat dry surface.
2. Underneath the juice bowl is the pulp extraction silicon, which is used to remove the pulp from the
spout of the juicing bowl. Ensure that the silicon is firmly inserted into the hole. (see fig.1)
3. Place the juice bowl on top of the motor base ensuring the 3 holes of the juice bowl align with the 3
screens on the motor base. Press down the juice bowl and rotate in a clockwise direction to lock it
into position. (see Fig.2 & fig 3)
a. Silicon plug in
b. Silicon plug out
Fig. 1
EN